|
Previous
| Next (Go to Step
4)
Pumping
Methods
Step
3. Entering the Tube & Securing an Airtight
Seal
Connect
your handpump to the cylinder. Re-lube your penis
(stay away from petroleum based lubes if you have
other than silicone gaskets). Also apply a generous
amount on your pubic hair. Try not to get lube
on your ballsac due to scrotum
suck. Now lube to the rim of your cylinder
then insert your semi-erect penis.
To
get a good seal before you pump, gently twist
the cylinder into your groin. This will apply
the lube around the groin and rub the lube with
the skin and pubic hair.
Once
this is done, a couple of presses of the handpump
should secure a tight seal. If not, try twisting
and pumping the handpump at the same time.
If
a seal cannot be achieved, the problem is in the
pubic hair. A simplest remedy is to trim most
of it off! You do not need to get a shaver or
anything, but a short trim of about a ¼
to ½ an inch in length should do the trick!
If
this is NOT an option for you, go with a thicker
lube, like hand lotion (with Vitamin E). This
should suffice.
Now
you are ready to pump!
Previous
| Next (Go to Step
4)
|
Home
> Enlargement
101 > Step 3: How to Penis Pump
